|
|
Toilet Problems And How To Fix ThemThe toilet cistern / tank takes a long time to refill after flushingThis can be caused by a faulty or worn fill-valve diaphragm. It must be replaced. Keep in mind that if you find it difficult to find the proper parts for the ballcock, it is easy and inexpensive to replace the entire valve.
Be sure not to let the float go down too far because the flush actuator will become hung-up on the float. One or two trial flushes will show you where it should be. To replace the diphragm and plunger inside the ballcock, remove the screws around the top of the unit near 'A' and lift these parts out. Watch how they come out and you will be able to install the new ones easily. To replace the ballcock completely, drain the tank till dry, disconnect the water line connection to the bottom of the tank, and then undo the nut from the underside of the tank while holding the ballcock steady with the other hand. If you count on the float rod to hold the ballcock from turning inside the tank, it will break. It's as simple as that!. Install the float rod to the new ballcock before tightening the new unit in place. This way you can see exactly which way it should point. Another possible reason why the toilet tank takes a long time to refill is that the tap leading into the tank is not fully open or is blocked by some other cause.
|
|
||||||